Quote Originally Posted by acelockco View Post
I have used the 2500 psi steel 95 and LOVED it. It was about the same size and weight as a Aluminum 80, but gave me a bit of additional air and better buoyancy.

Being that they are similar size and weight to Alum 80's they could be put together to make a nice and fairly lightweight set of doubles.

I don't know how much this matters to you, but I have heard that the higher pressures of the 3500 psi cyls help to wear out regulator parts easier. I don't know if it is true at all, but I thought I would toss that out there.

The other consideration as The Publisher said is getting the correct fills. I am under the impression that any dive shop in the US would be able to give you full fills, the problem would be on a dive boat. Some of the compressors onboard diveboats might not have the ability to give you complete fills. So you have to look into how much air you actually have at 3000 psi for those conditions. I guess it depends on what you are going to be using them for.

Now lets see what kind of great Faber deels pop up here.
You are right Ace, the higher pressures can cause lesser regulators to develop problems. However, there are regulators made for these higher pressures. I have had the high pressure seat go on my SP firsts, but my DR's are still holding strong seeing 4000psi on a regular basis.

As to shops not being able to provide a full fill - many of your rec oriented shops have a cut off on their compressors set at just above 3000psi. This is done to ensure safety when filling AL cylinders (keep in mind that most tank monkeys are young kids working for minimum wage); if the fill operator gets distracted while filling a cylinder the compressor will shut off prior to the cylinder being overfilled. This is why most cave divers prefer the lp steels, you can always get a full fill on them, and most times you can go beyond the rated capacity, using any compressor set up for Scuba.